Thanks mactec45! Works perfectly and I've now got it under RS485 control.
One question though... The lowest spindle speed with these settings is 7200rpm. Is that correct?
Type: Posts; User: Qubert
Thanks mactec45! Works perfectly and I've now got it under RS485 control.
One question though... The lowest spindle speed with these settings is 7200rpm. Is that correct?
Thanks for the fast response!
I'll try these tonight.
Hi all.
I had this VFD working great with my Chinese 6040 router when I used it last a few years ago. But recently I blew the dust off the router and the VFD settings seem to have been reset or...
Did you hear anything from Dolphin on an upgrade?
Never mind. I just dowloaded the trial and that was it!
Where can you download the new version from?
Hi all.
I just bought Dolphin Mill and was looking for manuals. Perhaps this is old news, but I found them for V13.3 at their UK website -> Manuals :: DOLPHIN CADCAM
There are also...
I can't speak specifically to the Carving-CNC machine, but I did buy a very similar 6040 off of eBay.
The mechanicals seem to be quite good. Like you, I use a Gecko G540 and a 48V power supply. ...
Too funny. I didn't have a clue I had a clue.
I simply reused the connectors from the original cables.
I don't have a clue where to find cable in Australia, but I bought mine in the US here. The cable linked to be Adverse Effects is a...
I bought a Chinese 6040 and based on the recommendations in this forum never even ran it with the included controller. I immediately swapped in a Gecko G540.
That worked very well in my dry...
I ordered a CNC 6040 a few weeks ago from "industry-village" on eBay. The seller goes by a number of names on eBay (location is always San Leandro, CA), but in the end the seller is apparently...
I'm coming up with the following travels: X=15-1/8", Y=19-1/4", and Z=2-15/16".
The only one that looks a bit less than claimed is Y which is supposed to be nearly 23". To tell you the truth,...
I'm in the process of setting up my new machine. I'll check the travel tonight and report back.
Thanks Foogl.
I'm glad to hear the positive report. It does look like a good deal.
As for the G540, do you still use the power supply in the original controller or did you also add a new power...
I am new to CNC and would like to get a router mostly for wood and plastic, but that is stiff enough to do some light aluminum machining.
I have been looking at the Fireball V90 and Comet, but the...