Just wanted to come on here and send a Thank You for all who responded and tried to help. It ended up being the encoder that was bad. I did replace it and machine is back up and running. Thanks Again...
Type: Posts; User: caddysnponys
Just wanted to come on here and send a Thank You for all who responded and tried to help. It ended up being the encoder that was bad. I did replace it and machine is back up and running. Thanks Again...
I just wanted to come on here and thank all who responded and helped.. It was the encoder that was the issue. Thanks again to all!!!
Good day all, anyone have any ideas on what would cause me to have zero input on the spindle speed. I can turn it on but it turns verrrrrrrry slow and can not increase the speed. Its a 2004 VM1...
Thank you DJ i will try that now. Also you are correct about never been able to get the spindle running. When i purchased the machine it had sitting for a little while and not had power connected to...
No Its still in the same spot as Before. I purchased this machine in Oct 2020 and to this day never used it because of this fault. Yes it does have the 626 Dive
No i never did get it fixed. I bought the machine in oct 2020 and to this day have never used it because i cant figure it out. I tried getting some service techs out here but it seems like they want...
Hey Servtech. the motor check out good. Would you know any tests i could perform on the driver to see maybe that's the issue?
First off thank you for taking your time to help, cause I do appreciate it a lot.
Ok i will check the motor now.
As far as the spindle being free, when the machine is off or not commanding the...
Good day all. I have a 2006 VM1 Ultimax with Yaskawa VS626 spindle drive. When I try and run the spindle it will only turn very slow and then will fault out with a OL1, which is a Current Over Load....
Good day everyone, wondering if anyone else have ever seen this or could please help me figure out what the heck is going on. Common sense tells me the door interlock switch but it doesnt seem like...