Search:

Hello,
My QT-18 has been powered down for several months.
Now we're getting "bus error at or near $004C0D96"
I have the initialization procedure, but hesitate to do that until I am relatively...

Can't beat an older Mazak if you are looking to save money. Parts are easy to find.
I must admit that I have somewhat of an advantage. I am one of the "old" Mazak service engineers, so I buy old,...

GRC,
Do you remember if you used the cable from the CMT unit, or one made up for RS232 transfer?
I'm trying to get the same software to work with my M2, T2 and T32 controls.
Thanks,
Southern CNC

The only two things that I can remember that would cause this is the chuck position (closed or open, internal or external chucking) and the tailstock position. There are probably two proximity...

Thanks for the service bulletin, mazak-user. Are the other service bulletins available online somewhere?
I'll give this a try with the CNCnet software.
Southern CNC

Thanks for the reply Rusty.
My control is the Mazatrol M-2. Could you tell me the pinouts of the cable
you are using? I've tried the cable that the CMT (the blue box with floppy drive) uses, with...

I take that as a no. I thought since it was free, someone would be using it for Mazatrol.

My Slant 40 does that when the air compressor is not on.
Most Mazaks do not look at the air pressure switch, however.
Good luck.

Hello, has anyone had success getting Mazatrol M-2, M-32, or T-2 to upload and download using CNCNet DNC? With the M-2, we can get it to transfer to the laptop, but when trying to load the same...