ok...I just ordered wire from them to redo the stepper motor wires, that is where I found my problem, I hope. Will order this also. Thanks for your advice
Type: Posts; User: tjcham01
ok...I just ordered wire from them to redo the stepper motor wires, that is where I found my problem, I hope. Will order this also. Thanks for your advice
2.2kw spindle
yes it is a water cooled spindle
the 4th pin at the spindle has continuity to the spindle body and the box, I missed that wire before, it is connected directly to the power supply ground
Think...
Using the pictures and my memory on this...the ground at the source plug has 2 wires on it. 1 wire goes to the power supply the other to the EMI filter where it has another wiring wire leave and go...
I have not done any wiring improvements. It appears the ground goes to the power supply, the EMI filter and the VFD, I don't think it is bonded to the enclosure
The VFD spindle has a 4 wire...
Update as I am still having issues...
I had been told to check the coupling tightness on the screws and all that was fine, that maybe it was just slipping occasionally, since it was so random. ...
So I made a 10x10 box 3/4" deep and it cut out as expected
I took my previous file which was 6 different cuts and ran each portion separately and it cut perfectly
Since I ran each separately, I...
Wondering if anyone else has experienced this issue, this just started over the weekend?
Running a China Zone 60x90
All 3 axis are calibrated and move accurately when doing the calibration...
Make sure your gauge height is correct on your offset page, use a caliper to measure, that is where 1001 is stored. You should convert all the numbers to inches if you are using inches...ie...in the...