The CNC was not turned off for a week.
Only the drive was turned off.
The machine worked without problems.
On weekends you need to turn everything off.
And after 20 minutes the power supply did...
Type: Posts; User: val62
The CNC was not turned off for a week.
Only the drive was turned off.
The machine worked without problems.
On weekends you need to turn everything off.
And after 20 minutes the power supply did...
Hello!
Power suply FANUC O-T A16B-1212-0100/08A this power supply starts up later every day.
Today it started in 5 hours.
The capacitors look normal
ON-OFF buttons work
When turned ON, the red...
Everything was repaired by VFS5!
And the PSR4 / 5 power supply was repaired.
The machine works!
Thanks to the forum and to AMERICAN FRIENDS!
KHARKOV
UKRAINE
I wrote to them!
So they are silent!
I'm still trying!
I don't have the original TL file!
I download from manul BDS5
Engine on the machine 1-604-0001
55A 230v 6000rpm
compensation module 275/2604?-010
Could this cause err18
I have exactly the same error!
What else to try...
Or just send it in for repair!
[email protected]
maybe the TL file is corrupted. ?
err 18 line 246 "EN" BAD TL
what to do about this error?
Is this error both hardware and software?
What commands can I use in TERMINAL?
what are the correct commands for MOTION LINK?
some examples please ...
Only ON, EN works in the TERMINAL.
Other commands don't work!
What am I doing wrong?
How can I see anything from the configuration in MOTION LINK TERMINAL?
What are the commands?
Does the forum work or not?
There are instructions for creating a VFS5 spindle drive configuration?
Or is MOTION LINK + enough !?
Who can I ask questions?
Who has a TL file on VFS5?
It is now detected when the voltage is switched on
ERROR 27 ”R / D JUMPERS” SEVERITY 3
Either the jumpers on your BDS5 MC2 card are incorrectly set or the wrong
TL has been loaded. Contact the...
??? ????????? ?????????????
CPU blinks continuously
now shines when voltage is applied
ACTIV
CPU blinking unpleasantly
How to do autoload correctly?
The LED is not blinking now.
When all voltages are switched on:
+ 10v
+ -18v
+ 24v on c2 pin 6.9
jumper on S7 MOTION, LIMIT
And on PSR4 / 5
Shines:
sys ok
Cpu
Our fan crashed on VFS5.
vfs5 monitors the presence of a fan?
Is it possible temporarily without a fan?
Can anyone help with the wiring diagram?
My electrical cabinet number
91203230
Thank you!
When the drives are turned on, the LED on the VFS5 flashes 5 times. + - 18 volts available 10 volts available.
MOTION LINK IN TERMINAL ERROR 83 AND 84
1.Sabre1000 machine
2. No wiring diagrams!