Search:

Amen brother that is an oldie but goodie. We actually have one at our shop where i currently work. LOL and you code! Man you got it all going on pal! Yea I can't wait to retire so I can play around...

It's a good point. Every part added is a point of possible failure.

Nice set up man! Did you ressurect an old machine? I've been a CNC Programmer for 44 years now. What type of lathe did you redo this controller on?

I'm designing a 4' x 8' x 12" CNC router with 4...

If you don't mind are those 1a terminal fuse blocks I see for the drives? If so can you tell me where you got them? Automation Direct is only showing 6.3a holders. Also what are those 4 devices next...

Hi Jim!

Thank you SOOOO much for this! I've been looking for an example for weeks now. You've got the power distribution block I was eyeing up too! Again THANK YOU!

Hey llilrex,

Despite using your T1 as the "zeroing" tool with G54, you should still have the ability to adjust the tool offset in T1's X & Z tool offset page. The technique you are using works...

Total noob here with decent electrical knowledge however I would like some feedback on the direction to go with my controller wiring.

I'm using DMM's DYN4 750w AC servo motors/drives and DMM has...