Search:

Hi CNCTech25
I was searching the site for info on the Fagor8025T controller and came across your post. Would you by chance have a copy of the parameters and decoded M functions. These were lost...

Hi Angelw.
I found this old post on the site regarding a fagor controller I have an 8025T without a plc. after the battery went ded I have lost all the parameters and decoded M functions. Would you...

Hi everyone
I have a fagor 8025T retrofitted to a LeBlond tape lathe. The connections seem to be standard to the instalation Manual . However I did not use it for a while and the memory battery...

Hi I have a Leadwell CHD 100 cnc injection moulder, unfortunately the control system has brocken. I think the E prom chip in the data entry keypad has brocken. The control computer is a Techmation co...

I thought dribble feed was a common definition , what do they uasaly call it when the program is to big for the memory on the CNC ,and the CNC runs it by grabing a part of the program and runs it...

Hi guys
Hurray I have done it, I have full DNC with Dribble feed in jumbo mode.I will write it in simple words as I do not now anything about electronics (apart from getting electricuted the other...

Thank you superman
I have obtained a copy of DNC 7, I have version 5 dnc controls so they both have the same functions including JUMBO (which is what I need). I also have obtained a DNC manual,...

Hi sprinter
I have seen the thumbnail picture of the anca DNC program, and I think it is what I need to get my DNC working. I dont think I have the appropriate dos based programs to talk to the ANCA...

Thanks guys I wil try your sugestions
I have tried the jumbo mode but mostly got a message saying Fatal error see computer operator. Hopefully todays info you and superman provided may get me past...

Hi sprinter/ superman

I am wondering if I do have the update , I havnt tried supermans reply of using the full file address yet but will do it today

The DNC page has the following options
1...

Hi hatcat
I have just joined this thread as I also have problems with my ANCA mill.
I am having trouble using the DNC function.
My machine is the ANCA 2000 Version 2.3. The DNC page says series...