I used an older lib file and adjusted it and got it to work, thanks for the help.
Type: Posts; User: Georgefs
I used an older lib file and adjusted it and got it to work, thanks for the help.
I still have the unchanged mill.lib file. I have a fancmd.lib which is the same as the mill.lib I attached. I renamed it to try to get it to work.
I'll try it again with the Fancmd.lib file.
Thanks
Here they are.
377796
377798
I get an invalid file message when I try to upload the files. Any tricks to upload files?
I've tried that but it just puts the list after the :SECTION=INIT_TOOL_CHANGE_MILL
I've tried about every location I can and still can't get the right result.
I can't get it to move to just after...
In the UPG go to sections, rapid moves, 1st rapid z down. Delete the <G:43>
You may need to move the ctl file after you compile it. Or change where Camworks is looking for the ctl file.
Right click machine then the post processor tab to see what the active post location...
How can I do this? right now my post outputs the tool list before the program. I need to list the tools after the start of the program.
I am using this line in my Lib file
:C:...
Here's works on my Okuma.
Turn the machine off.
Turn back on.
Go to manual and push the black button on the upper left side of the control(magazine retract) and at the same time push the interlock...
Hi Everyone
I've been using Camworks for a long time and I ran into a problem I
have never seen before.
When I create a new part for turning I start the machining process
but I can't go and...