Search:

Thanks a lot John. I have a syil with a smoked spindel controler. I don't get any spare parts from syil. I have a infranor servo controler and servor motor. That runs with a signal cc aud cl. For the...

Hello
I have the a BOB for mach 3. In the manual there is nothing about the spindel direction. It is a 5 axis board. I need just 4 (X,Y,Z,A). Is it possible to use a pin for the 5 axis?

Hello
I have a blown Syil Xp5 spindel controller. I want now to replace the controller with a servo controller and a new motor with higher torque.
In order to have the same functionality (rpm,...

Hello
I saw that you had a problem with the spindel controller MBL-1100-300H. On my controller is a electric part blown. Could you please tell me the type of the element marked yellow. I can't read...

On one side there are 4 connector and on the other side there are 3 conector.
Attached a picture from the back side. I saw ooictures of other Syil spindel controler and they look pritty much the...

Hello
I have a Syil XP5.(from 2009). The servo controller of the spindel is out of order. The machine moves without the spindel controler.
The print type: MBLC-1100-300H / 1100W/3500RPM/220V. I...

thanks a lot. I am going to sustitute the wire.

Hello
I have a syil xp5. I have a broken cable to the optical home switch in Z-direction. It is brocken because it was mechanicaly trapped somewhere in the constuction. This is not the first time...

i'd like to determine on my syil xp5 the tool length with a mach3 macro.
I connected a switch to the a-limit switch (current thread on cnc) on the brekout board (input pin 15). When pressing the...

hello
my syil xp5 somtimes stops when the cooling switches off. I have to reset and can countignue the work. I guess there is some electronic problem. Is there anybody how knows how to solve the...

thank you peu
where can i set the debounce interval. is this in mach3?

hello
I have a syil xp5 linear. I had to take the machine into parts because of clearane in the z-spindel and some other mecanical problems with the y-axis.

I have now limit switch trigger during...