I have had a unit from Gotek model SFR1M44-FEL-DL and I'm having a similar issue. If I copy a file from the PC to the USB and then try to read it on a 7000L control I see no file (this is in MSDOS...
Type: Posts; User: akl-kiwi
I have had a unit from Gotek model SFR1M44-FEL-DL and I'm having a similar issue. If I copy a file from the PC to the USB and then try to read it on a 7000L control I see no file (this is in MSDOS...
Ok here is my thoughts...
Since the STM lamp stays lit it is waiting for something to be in its place before continuing its program. So lets consider what is going on....just the chuck closing...
calgarykevvy you comment about intermittent spindle handover has me intrigued could you please elaborate on what's your problem.....
Hi Guys,
Just to jump in and reply to broby comment about powering off quickly.
If you look in either the top left or top right corner of the screen (on older OSP5000/5020 controls) you will...
If you email Okuma Japan directly they will forward you enquiry to your local agent then they should contact you to assist you.
64 alarm P Peripheral processor Start 11
This alarm basically mean the machine cant find something it is looking for, it might be a card in the CPU rack it could be an encoder the answer is in the...
A copy of the test procedure
A manual for you all
Opps cant upload....
Have you done the FTP logon loop back test on the pc using the GET PUT commands.
Then if you can ping the machine it should all work ok.
Please look towards the back of the DNCDT setup manual....
M210 Spindle synchronized rotation phasing cancel command
M883 Interlock release for both spindles being clamped
As BudgieW says it works a treat but the commands must always be used on the same...