Search:

look at the cutting chart, there are the common working voltages. I would say 75v to 225v range is okay

To control HPR machines fully, you will need a combination of CAM and control software. This is required since the features like True Hole need to be activated at Gcode level. For example, during...

what is the most suitable machine to cut stainless steel, without burr or discoloring?

I tried e*******n , m****a brand cold saw, but the bits chipped after few usage , so I am thinking about...

Choose a controller that has complete user manual.

Is there any downloadable user manual available for HPR130XD ?I cannot find it on Hypertherm website.Thanks

Update: I bought chinese plasma cutter to replace the dead PM65, I use it it for 2 months now, the cut quality is not as good as hypetherm , but hey it cost less than half of repair cost , so I...

It's been 3 days without anyone reply.

I let the machine die, it is too expensive to repair if I don't know what the problem is.
The problem may arise again in the near future.
I am going to...

My PMX 65 stopped suddenly in the cutting process. Upon checking, Hypertherm technician informed to replace following items: 228707 IGBT 228659 Powerboard 228909 display module It is expensive...

"quality always comes with price,
expectation always exceed reality"

use the output voltage to power a 5v relay ....google 5V relay
then use 2 legs of relay output to the BOB

try to select all entities,
transform translate
pick a point and type origin

A friend of mine has bought a cnc router with RZNC A51 controller.

in manual mode, when jog button is pressed ( X+ , X-, Y+, Y- ) the machine wait for a while (like 0,5 second) , then it moves as...

HI Al,

I also would like to know about it.

Please PM

Thanks

try M1060 to M1076, that are all other reserved sharp Mcodes

if it was running fine, i suspect there is a loose connection to control board .
check wire distribution box near atc, pull the wires and put back on, one by one
do the same to wires connecting...

agree with cncman172

Hi josetarifa, thanks for reply.

I just solved the problem, it was loose cable at the terminal box near the ATC

my machine has umbrella type tool changer, Fanuc 0iMD control

Yesterday, during tool change, the magazine did not fully forward due to leaking airhose.

after i changed the airhose, i power it...

SOLVED : loose cable


I have MVC300 (SV2412) umbrella type tool changer, Fanuc 0iMD control

Yesterday, during tool change, the magazine did not fully forward due to leaking airhose.
after i...

check wire that connects optical switch

enjoy

Just disable finishing operation with endmill 4mm

Use 30A consumables

the encoder is an absolute type, so I would say the problem is with mechanical parts, like loose gib or something.

You dont need coolant proof glass scale , really..
I have opened many glass scale, they contain only a glass strip + small electronics on spring loaded pcb.
Suppose coolant get in between glass and...

Try this :

semoga berhasil

5A is not suitable for that motors.
Usually 3.5A will sufficient .
Set to 3.5A , If there is a lost step then you may decrease your cutting speed

exactly

try to do finish (full depth) contour cut at the last process,
it seems you just use stepover contour to finish

try gecko drives , you save lot of time needed to setup.