Search:

So the rated voltage in the documentation shows 3 volts (kinda makes me scratch my head). They have Inductance of 2.5 per phase and a holding torque of 570 oz In KL23H2100-50-4B is the motors.

So I am to the point in my build that I need to order my power supply(s). I am planning on either 36 or 48volts and need 13.2 amps if I run a single supply based on the 2/3rds rule running four 5...

Did not even notice those were ac drivers. That break out board is interesting for sure. I found this description for it on amazon and googled it 0 documentation but there is an instructable may be...

Yeah I think your big power supply needs to be ran to your drivers and not through the BOB. I have only wired a setup once but it worked the BOB I used only used 5v but is different than yours for...

I am looking at exactly the same thing. I honestly think there is a ton of value in their prebuilt plug and play systems. However to get a machine up and going no doubt it can be done with less...

So yep another one of those builds...:)...A little about myself first though, I've been woodworking for the majority of my life and can make some pretty things once in a while. I have been...

Making something real move using the Computer is alway fascinating. I am right around the same spot you are building my first and when those motors went to work the first time it was very...

Electronics-Lab.com Blog . Inspiration for you seems they used very small motors on this.

I am new to this stuff too, but did research that board as well. It requires a5v signal or can be modded to aaccept a 3.3v signal. The GPIO on your RasPi will do 3.3v it could be used and some...

I am new to this stuff too, but did research that board as well. It requires a5v signal or can be modded to aaccept a 3.3v signal. The GPIO on your RasPi will do 3.3v it could be used and some...

Okay figured it out and solved a couple of other issues along the way. This comp is an off lease special and evidently no one ever thought to reinstal parrallel port drivers...no options for...

So I have accumulated almost everything for my first cnc build and in testing my electronics I have encountey a problem. My drivers hold my steppers when powered and I have carefully determined how...

Hello all I am a newbie just starting to build my cnc router. Funny thing is the more I think the bigger it gets, go figure. Lurked and looked for a while but now begins the time to pick some...