Search:

Hello,

I'm currently working with a Mazatrol T32 control system on a 1993 Mazak SQT15 lathe. I'm encountering an issue where, regardless of the setting chosen (e.g., Drill bottom, Peck bottom)...

It happens at the nearest flat area on the part at an intermediate step.

this is the first roughing pass.

The problem happens when doing some deep side milling using adaptive rough with intermediate steps. As the part tapers the tool path will calculate full engagement or really large stepovers. Causing...

I am looking for extra fadal parts to have on hand. We have both 4020s and vmc 15s.
Looking for spindle drive, 190-510vac transformer, amps, motors, etc.

Thank you

Hello,

I have 2 complete 1400-5 controls. Includes motherboard with card cage and all cards in like new condition. Running software 102.1 and each system has 384k memory expansion board.

I...

Hello all,

I have two 95 4020s both with 1400-4 systems. I recently acquired two card cabinets with 1400-5c cards (all cards)

I'm curious if there will be any noticeable difference in...

We are located in Provo Utah

We have a 98 arrow 1000 with 2100 control had machine for almost 2 years and it never gets used because no one knows how to use it.

Would anyone be willing to do a remote skype training session...

Okay so tram height is only for tool lengths reference easy enough. How then do I ensure my machine table zero is set correctly? And if not how do I recalibrate it? I cannot find this anywhere in the...

Hello I'm setting up a new to me arrow 1000 with acramatic2100 control.

When setting spindle tram for then setting tool lengths how does the machine know where the top of the table is? Say I set...

no probe just an edge finder and z setter. the only thing ive done with the machine is align and jog around. everything else is new.

98 arrow 1000. I too am self teaching and it's a pain! Any help is greatly appreciated.

Curious if someone with a acramatic 2100 control would be willing to film the basics of setting up the control. Things like fixture offsets, setting up tools, loading a program? This control is very...

Mike Kilroy spent time with me on the phone and remotely on motion link diagnosing the issue, we found the resolver to be at fault. A big thank you to Mike for all his help!

no, I have yet to...

Hello,

I recently acquired a 98 arrow 1000 with a "spindle drive is not responding" 39-81 alarm. I sent the VFS5 in for a rebuild (Kilroy corp) and installed with the same alarm. I've hooked up...

In my experience I had this happen on just about every program I tried. rendering the software unusable. Been programming with fusion in the meanwhile with zero issues using arc fitting or anything...

Found the problem with the help from jrmach. Arc fitting was causing the issue. Something was wrong with the ijk lines in the code deep in the program. Unchecked arc fitting and reposted the program...

I don't have predator software. attached is the Gcode for the part. if someone would be willing to check it out for me I would really appreciate it. I have all the recommended link settings in Bobcad...

It's a fadal.

It happens during cutting feed not during rapid but is dog leg in shape.

I'm having issues where bobcad will go severely off path and gouge the part breaking the tool and ruining the part. However there is no evidence of this in the simulation or code. I've tried various...