Never mind. I wrote a post processor that works. Thanks for all the help.
Type: Posts; User: Mike Sandor
Never mind. I wrote a post processor that works. Thanks for all the help.
I recently upgraded my 425 tree using Candcnc servo system. It is Linux based.
I currently run Vectric Aspire on my cnc router with Mac 3. I would like to use Vectric
On the Tree untill I can...
I just pulled the spindle motor off of my 435 today. I am selling all three motors and the rest of the electrical system minus the vfd and spindle
Motor. The the drive cards are already sold.
Sorry Stu, the three drives have been sold.
I am looking at a few options regarding the vfd. My electrical engineer here at work set up the vfd and motor on a test bench. Wired it three phase to confirm that all worked well. He then wired...
Not sure where you ended up with this. I had very similiar issues and yes, the system is loosing steps. Only when the program would rapid to the next location. A reduction in the speed of the...
I just scored a J425 mill from the model shop where I work. Purchased new in 1998, limited use in a non production model shop, mostly plastic, some wood.
It was pulled from service in 2003 due to a...
Louie,
you are correct, as I am new to this gantry stuff. I am in process of building one as we speak however. By the way, are you the same "Louie" I read in the MIMF instrument forum?
Mike
That is what they call "tramming the head". You need to attach a indicator to the spindle, with the indicator extending out say 6 inches. Lower the spindle/indicator to the table. Rotate the...