Search:

hello,
We have a problem with a Motor Drive Control.
The CNC is a TRAUB TNS 30/42 - but i think this is a general Motor Drive electronics problem ,

The Machine has a AMK Arnold Muller motor...

hello, Mr Sauamikat'
you have helped me in the past with your knowledge.
i have a problem with a Traub TNS 30/42.
the machine will power up ok , no alarms .
when the drives and hydraulic button...

Thank you for your advice , i shall email Uwe and ask for instruction regarding accessing the parameters and changing the display to English ..

HI thanks for your reply,
Yes the problem was in the lower operators panel, i air cleaned the board and re-adjusted a twisted ribbon connector.
all is fine ,
thanks ,

hi ,
thanks for your reply
It seems that the TX8 Check menu pages are not identical in the different versions.
I do know Uwe , and you are right , he is most helpful and knowledgeable , i shall...

THANKS FOR YOUR REPLY.
OUR MACHINES ARE OPERATING ON TX 8D FORMAT .
I BELIEVE THE CHECK PAGE FORMAT IS DIFFERENT TO YOURS , THERE ARE MANY PAGES .
ALSO CAN YOU DEFINE " BASIS 2 PARAMETER "...

Hello
I have a TNS 30/42 ,
the machine was running but all the L.E.D lights on the operators panel were flashing during the machine cycle .
when cycle finished i powered down the machine and...

Hi i am fishing this forum for some help or advice.
Have just bought two Traub TNS 30/42 machines, the current language on screen is German , would there be a parameter setting change for on screen...

The machine will be disabled if any parameter has been corrupted, the 401 alarm is not specific to a fault it is telling you that conditions to start up are not being met.
if there has been a...

Hi i am fishing this forum for some help or advice.
Have just bought two Traub TNS 30/42 machines, the current language on screen is German , would there be a parameter setting change for on...

Hi have you checked the overloads for the drives in the back cabinet and also all fuses , obvious i know but sometimes missed and make sure they are reset, i have had this alarm before , check your...