Search:

I already get those files.
If anyone need them just let me know.

Regards.
cncwar

Hello everyone!

Due to unknown reason (for me) our lathe - SPINNER TC 67 H - lost both parameters and PLC program. Now i have a big problem because there was no backup. Without required files...

Hello!

We have problem with ATC on our MAZAK VTC-20B. The problem is that it's not moving to extend position in manual movment. First i checked all input signal and they are ok.
So i decide to...

I would be very thankful if You are able to send me setup sheets. the only technical documentation i have is a schematics for my particular machine.
I'll try to set machine as You mentioned (Kv=2.0,...

mike_Kilroy probably means the screen attached below. I knew this trick and of course adjust the gain so that following error was the same in both axis while runing at the same speed. In my opinion...

No. Kv nominal and Kv adjustment are both to change using operator screen (on Axes and Servo screen).
When i got this machine the Kv and Kv adjust was mismatched. I was like Kv =2.2, KV adjust=0.36...

I made adjustment using pots on BDS4. First of all i had to compensate a zero speed drift. It wasn't big by the way (~1RPM). Then little adjustment of gain and range. Unfortunately my problem is...

thank You for fast reply. We did that three time. Using different tool methods and person. Besides adding a backlash we can see significant changes on surface ( in place where move direction are...

Hello!
We bought Arrow VMC-1500 with A2100 and Kollmorgen BSD4 drivers. Machine works fine except one thing- it has a interpolation problem. Let say we are milling a square - the dimensions are as...

i sugest check a precharge resistor in drive unit and bypassing resistor

My security device electrically is OK. I've checked it in two ways. First i wrote a VB program - and i got response. Second, I used an AVR platform and also device responded. If so, that means that...

Have You still got the Heidenhain docs for this interface? I can't find them any where...

cncwar

CPU Board looks like this:
319564

Hello!
Long time no one post within this topic... (hope someone will see this message :).

I'm facing the same problem - during start up, i've got message "security device is invalid or has...

Hello!
We've got the same problem. No tool holder (and pull stud) for our Chiron FZ12S. Does anyone know what kind of tool holder is used in this machine?
I put the SK40 taper into the spindle and...