You're using a g91 for a sub program? G91 is incremental positioning. I would use a m98 for a sub program. All the machines that I know of use a g91 g28 z0 and g28 x0 y0 for homing except maybe some...
Type: Posts; User: miwaba
You're using a g91 for a sub program? G91 is incremental positioning. I would use a m98 for a sub program. All the machines that I know of use a g91 g28 z0 and g28 x0 y0 for homing except maybe some...
HiI wanted to add something to this as I try to find out what is going on here. I replaced the two trim pots I thought were bad and nothing changed. On the servo amplifier there are ten small...
TimothyThanks for the reply. I got it straightened out. I put a G90 at the end of each tool. The thing I didn't understand was there is a G90 on the line with the workshift that should of taken care...
I'm really stuck with this limit switch problem. I have a dm2800 converted over to mach 3. I set limit switches by moving axis until limit switch was activated backed it off where it wasn't activated...
Hi
I have a dm2800 and the spindle will turn up so far and level off. With the belt in the middle pulley it is about 1600 rpms and it should be 3750 rpms. On the top belt it runs at about 4600 rpms...
Thanks for the reply. I found out what it was. I looked at the instructions again for the pendant and see I loaded it wrong. If wiped out the ip address for mach3. Going to reload and it should work
I shut it down the same as I always do. It's not just the pendant that isn't working nothing is working. And there is nothing telling me why it is not working. Thanks for your reply
I have been working on converting a dyna mech dm2800 over to mach3. I'm using a g540 and a ESS. Had a little trouble here and there but got it working all but the limit switches. I bought a P1A-S...
I
Jim
Thanks for the reply I guess i'll just have to try it
Can anyone help me figure out how to setup my stepper motors? I just can't seem to get it. I have a dyna mechatronics dm2800 using mach3 with ess. What I have here is right out of the dyna manual....
Hi guys
I have a dynamech dm2800 i'm converting over to run with a gecko g540 with a smoothstepper. I'm new to all this but I have made some progress. After some time I got the z axes wired and...
can anybody help? I have a dyna mechtronic dm2800 mill with artisan/ahha software. New to benchtop machines and pc controllers. Just bought this machine awhile back and have not got to use it yet....
to anyone interested i'm having a transformer made for me. I contacted watertown transformer. I told Mark the person I contacted that I would put there name out there for anyone needing a...
I have a dyna mechtronic dm2800 whenever I plug it in it will blow the fuse at the power cord.I tried slow blow fuses but same thing.I unhooked the wires coming out of the transformer going into the...