Hi
I get problem to startup. I push start bottom then i need to whait 1-3 hours before machine will start. I mesure i get signal from relay to powercard. So the problem is the powercard. I search...
Type: Posts; User: angorgus
Hi
I get problem to startup. I push start bottom then i need to whait 1-3 hours before machine will start. I mesure i get signal from relay to powercard. So the problem is the powercard. I search...
Hi
Now i find the solution !!! The NC optional parameter no 2 bit 7 set to 1. standard is 0 No buffering for next raw in program :) now it´s work perfect !!
Hi
We have test lot of parameters and codes but still get stop....how can i see if a code is active ? Exampel G60,61,64
Krg
Göran
Hi
See my program
Hi
I have test 0.005 and 0.015. 0.005 is working with very very smal stop. 0.015 is not working. I get smal stop.
Krg
GG
Hi
I test 0,015 this not work. 0,005 is 95%..Is it not possible to get 100% no stop at all ?
Krg
GG
Hi please explain for me how VIN* works. I try to send you a video but i get error....
Krg
GG
Hi again !! It work 95%... it still make a very very smal stop. I will try moore tomorrow.
Krg
GG
Hi
Thanks i will try this. Do you know the system parameter i maybe need to change ?
Krg
GG
Hi
Sorry i not understand to answer you ???? I milling on steel and if i go like this prg
G00 X0 Y0
G01 X0 Y200
G01 X0 Y300
The machine make a very smal stop for each raw in prog.
Same if i...
When i try to mill a cirkle or a line. The machine make a smal stop for each raw in prg. I think its some parameter i need to change. Someone who know this issue ?
Hi some one who know how to change spindle pin on okuma mx45 bt40 ?
Special tool and sealing ?
Krg
Gg
Hi
We interupt the work in machine when the tool magazine run..... now it's not in poistion and we get alarm "2480-14 axis change control unusual TS axis 3
Some one how now to fix this ?
Krg...
Hi we have problem to startup the machine. Get alarm 4269 APC version Error 33
Please help me with this
Krg
Goran
Hi
Someone who have electric wiring diagram/drawings on a Brother TC-225. I will connect handwheel and need to know where :)
Hi
Yestrday i work with my okuma LB15. suddenly i get E-stop. No e-stop is pressed. I need electric drawings for e-stop. I can put a jumper on terminal and see if e-stop i gone. i can be a lose...
Hi. I have a problem with my brother TC-225. When i start up the machine and then go to zero point with MRTZ i get Deviation error Z. If i try to move Y or X axis on rapi mode i get the same...