Hey guys/gals,
Not sure if this is the right place to post this, but here goes. I need to get multiple programs on and off a Fanuc 31i control on a Doosan HP6300 Horizontal Mill. I am doing some...
Type: Posts; User: yore123
Hey guys/gals,
Not sure if this is the right place to post this, but here goes. I need to get multiple programs on and off a Fanuc 31i control on a Doosan HP6300 Horizontal Mill. I am doing some...
Hey guys/gals,
Not sure if this is the right place to post this, but here goes. I need to get multiple programs on and off a Fanuc 31i control on a Doosan HP6300 Horizontal Mill. I am doing some...
Hey Stephen,
I never saw your reply as it was almost 5 months after my post and we had resolved the problems that we were having at the time. However, since we are having new problems I reGoogled...
Can you explain a little about how to check the change of state of the switch?
The machine serial number is: HP63000157
The pump type is: SKF MKU11-BW6-0428B Serial Number 1401
Darryl,
Thanks again for the help. In watching the gauge while the machine is running it will cycle normally (into the green) 4-5 times without alarming, and then on a seemingly normal cycle...
I have a Doosan Horizontal Mill HP6300 with pallet pool. I am getting alarm 2161 quite regularly and nothing seems to fix it permanently. Resetting the machine will clear the alarm, but it seems...
Just wondering if anyone here has any experience with the Kiwa KNH-400 with 6 pallet pool? We just got a used (very used) one and I have been trying to get it up and going. The main issue that I am...
DrDos,
The control is a Fanuc 31i. I know for a fact that it doesn't have C axis capabilities. Our Haas doesn't have a C axis, but you can orient the spindle to whatever degree you want to. ...
I'm on another job right now, but will give that a try when I go to that operation. Thanks for the input.
We have an HP4000 Horizontal Mill that we are needing to do some broaching on. I don't really want to get into the whole "You should/shouldn't do that on a milling machine....etc." My boss wants...
We recently lost the 9000 programs in our Doosan HP4000 machining center (long story). Our dealer gave us what he thought were the original 9000 programs in the machine. However, we are having a...
It turned out that the battery was dead on the Pro-Motion Servo for the turret. Replaced the battery and reset the parameters and we're good to go!
I pulled the back cover off and can see that the turret switch sensor and the DOG appear to be functioning correctly. The sensor lights up when the turret is clamped (5.4=0) and the DOG moves...
Hey Darryl,
I am getting the 2047 error on my Daewoo MX2000ST. If I toggle keep relay 5.4 I can get it to clamp (0) and unclamp (1) to where it spins freely by hand. However, the alarm won't go...
Hi All,
I have some Sharp mills with Fanuc Oi-MD controls. I have Gibbs posts that work for them when only using a single station (G54). What I need is a post that will support multiple stations...