Search:

https://we.tl/t-zO9ici6A2d

Hello.

* I want to connect the inverter Jaskywa VS-616PC58 / P5 to the Mach3 USB Motion Card (AKZ250) to Spindle speed PWM output. I would like to have a speed control.
* Please, if anyone can...

Hello.

* I want to connect the inverter Jaskywa VS-616PC58 / P5 to the Mach3 USB Motion Card (AKZ250) to Spindle speed PWM output. I would like to have a speed control.
* Please, if anyone can...

Home

Fanuc 3M drip feed upgrade chipset for A16B 1000 0010 | eBay

FANUC SERIE 0-MC
SOFTWARE: 0469-21
TYPE: A02B-0098-B511

1. Drilling with CANNED CYCLE doesn't work. During the course of program, no error is shown – the program just skips the lines where the...

You need instructions on programming or on machine? First I need to scan. Maybe I will have time over the weekend.

HI

Check you this 4 parameters; No 4 for X axis, No5 for Y, No 6 for Z, No 7 for 4TH or W (second z axis if you have two z axis)

http://www.shrani.si/f/2n/lO/FR3xmFN/scan0005.jpg

Sorry for...

I will check tomorrow in manual which parameter provides a step motor in individual axis.:)

Hi.
I have two machine with Fanuc 3000c controls. I use PAC 3 program to communicate DNC through the LPT port (in DOS mode) Programmable in 1 /100 millimeters. Punctuation is not used! 1mm=100 ,...

Thanks.

Unfortunately I'dont have G61, G64, G09 commands. When writing commands appears ERROR NO. 10 (unusable G code was commanded)

Thanks.

Unfortunately I'dont have G61, G64, G09 commands. When writing commands appears ERROR NO. 10 (unusable G code was commanded)

I have a NC milling machine FANUC with FANUC 3M control (rom version D71-04). I have a problem when milling sharp corners. The corners are not sharp or edged but are rounded instead. The machine...

Hello.

We recently bought the upgrade chips for Fanuc 3M . After the upgrade (version D71 - 04) it is supposed to get direct DNC control between machine and PC (drip feed) and thus no memory...

Thanks for your answer. But my 3M (version of software D71-04) have only 99 parameters. :confused:

Hello.

I'm upgrade fanuc 3M (replaced 10 control chips on the motherboard). Machine now working 3-axis control simultaneous only on linear (G01 X50. Y50. Z-50 F3000) I' need to work helical (G02...

Hello.

I'm upgrade fanuc 3M (replaced 10 control chips on the motherboard). Machine now working 3-axis control simultaneous only on linear (G01 X50. Y50. Z-50 F3000) I' need to work helical (G02...