Search:

The relay board is from buildyourcnc, the actual relay is Omron G2RL-14. the 5V power supply is rated for 300mA.

Sorry I have temporary setup so my wiring is a mess.

I have tried replacing...

I'm trying to get the outputs on my G540 setup with a relay to control a router but I'm running issues. Attached is a sketch of how its wired up.

Without the relay wired and linuxcnc set to...

It would be cheaper on the shorter axis but they are less prone to racking. The longer axis is typically much wider so having screws on each side helps it be more stable

I'm in the planning stages of building a machine. How much should i be concerned with wire length? More specifically is it better to have the hobbycnc board closer to the steppers(shorter stepper...

Thanks, well the laptop decided to give up completely so the problem fixed its self.

I have heard that a million times not to use a laptop but of all my old computers it ran the smoothest with...

I have been running linuxcnc on my laptop for a about a year now with no issues. I dont have a machine built but I hope to soon if i can sort out my computer issue. Before i was getting latency...