Allen, thanks again. The drive is a yaskawa F7. It has a parameter for reference jog and thats what did it.
Sent from my SM-N900P using Tapatalk
Type: Posts; User: Elmss12
Allen, thanks again. The drive is a yaskawa F7. It has a parameter for reference jog and thats what did it.
Sent from my SM-N900P using Tapatalk
I will look in the drives manual tomorrow for a parameter for it. I forget which drive is in the machine. Was changed about 1.5 yrs ago.
Sent from my SM-N900P using Tapatalk
Hello All,
Hoping someone can help me out with what to check. I have a 1995 MC-20 VMC ser# 4016. I recently changed the spindle belt position from low to high and am having problems with it...
Found another plug loose behind the front panel. All works as it should now with machine. Just gotta get new air valves for toolchanger. Air leak runs the compressor.
Thanks again,
Seth
...
Emailed milltronics and Mark helped me out with checking out a few things. (Impressive service considering age of the machine).
Mark got me down to the interface board, so I decided to reseat all...
Sportybob,
Thanks for the info. The ser# is 4016.
Hopefully it comes thru but below should be a pic of the tag on cabinet.
Thanks Seth
222048
Sent from my SPH-L900 using Tapatalk 2
Sportybob,
Forgot to include I did double check the voltages in coming and at taps.
226v across 3 legs incoming to machine.
114v out of transformer.
Sent from my SPH-L900 using Tapatalk 2
Ok, git some time to look at the machine today.
Sportybob,
the power supply I have has the 3600mfd, 450vdc cap and 240v fans which from what I can tell the 308vdc should be in ok range.
ZZZZ,...
Hey ZZZZ,
Thank you for the info, I will try to narrow down which drive it is. Any info you are willing to send is greatly appreciated.
My email is [email protected]
Thanks Seth
Sent from...
Hey Joe, Thank You! I appreciate the help.
Seth
Sent from my SPH-L900 using Tapatalk 2
Hello All,
I just acquired an 1995 VM-20 with the centurion V. The spindle drive comes right up and is showing no faults on its screen. The 3 axis drives have no leds lit as if they are off?
I...
I am looking for manuals for my Wasino lj103m lathe. If no one has the manual but knows the m-codes for machine that would be really helpful. Mine is a 1986
Thanks Seth
Sent from my SPH-L900...
Thanks for the info, i had tried that. i got a hold of mitsubishi and found out it was a board in the control.
Hi,
I have a 2001 4020 that i had a similiar problem with. I had to hit the resets on the tool change board in the electrical cabinet. after it was reset had to reset and re cold start machine....
I Have a okk mcv 460,like the 500. i had the machine running the other day,was fine. Shut it down for some maintence, when started back up got the ready light, then after a few seconds got alarm...