584,846 active members*
4,636 visitors online*
Register for free
Login

Search:

Type: Posts; User: punkinbeck

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    610

    Fanuc noob question q setter

    Hello,

    We recently purchased a Doosan 2100 LB with Fanuc control.
    I'm not very familiar with this control yet. I wasn't sure if I'm using the q setter properly.
    I'm running the Q setter on X...
  2. Replies
    1
    Views
    846

    Re: Fagor 8025 GP following errors

    Normally you adjust following error on the drive itself, but if it ran fine before I can't see that being an issue. Are you encoder parameters set properly?
  3. Replies
    0
    Views
    753

    Spindle speeds wrong on 8050 lathe

    Hello. I was hoping to get some help correcting spindle speeds on my 8050.
    Theoretical RPM and actual are not matching.
    I wasn't sure what parameter to adjust to fix this.

    Machine has a...
  4. Replies
    0
    Views
    824

    Spindle speeds wrong on 8050T

    Hello, I have a Toolmex lathe we just had to replace 8050 CPU on. We uploaded new parameters to the 8050.
    The spindle runs but does not run at correct rpm. 1st gear the machine will only run at...
  5. Replies
    1
    Views
    615

    looks like i need mach 3 and sheet cam

    looks like i need mach 3 and sheet cam
  6. Replies
    1
    Views
    615

    Looking for simple software for g540

    Looking for some CAM software to operate my gecko G540. I am building a machine to profile pipe for very simple pipe saddle joints. We currently use plate and sheet professional, print templates,...
  7. Thread: Fanuc 20t

    by punkinbeck
    Replies
    8
    Views
    2,231

    The fanuc 20t doesn't have a memory card slot on...

    The fanuc 20t doesn't have a memory card slot on it. At least I haven't found one anywhere inside/outside the machine. I can either use a DB9 or DB25 more than likely I will use a DB9 so I can...
  8. Thread: Fanuc 20t

    by punkinbeck
    Replies
    8
    Views
    2,231

    Okay great. Sounds like I just need to make up...

    Okay great. Sounds like I just need to make up an adapter for a standard cable.
  9. Thread: Fanuc 20t

    by punkinbeck
    Replies
    8
    Views
    2,231

    Fanuc 20t

    Hello everyone,
    We just purchased a takisawa 560 lathe with a fanuc 20t control.
    I don't know much about this control other than it's not very common here in the U.S. This control has a 25 pin...
  10. Replies
    3
    Views
    790

    thanks for the reply. I'll give him a shot

    thanks for the reply. I'll give him a shot
  11. Replies
    3
    Views
    790

    Also I am looking to cutt out just simple pipe...

    Also I am looking to cutt out just simple pipe tie ins and holes for fittings
  12. Replies
    3
    Views
    790

    Looking for software running g540

    Hello all. I am new to this forum and I hope I am posting in the right section. I am in the process of building a CNC pipe/tubing cutter. Basically one axis that goes along the length of the pipe...
Results 1 to 12 of 12