Search:

could solve the problem? Please indicate how. I have the same problem but only with the Z axis

Nazario

hello
I have a problem with the same drive.
Please send me PDF manual of spindle drive.
my email is [email protected]

diagnostic # 33 bit 4 = 0
diagnostic # 97 bit 4 = 0

when you place a jumper between pin 33 and pin 35 of C03

diagnostic # 33 bit 4 = 1
diagnostic # 97 bit 4 = 0

this means that the...

I have the replacement for this board, set the jumpers as the one in the machine and replace the board but the problem is not solved, any other option to solve this problem.

regards

Nazario

check the wiring diagram, C03 pins 34, 35 and 36
these pins are disconnected (no use)

also check the cables, these are loose


Regards

Nazario

I have a four-axis Bridgeport horizontal milling with FANUC 6MB Control, I can not move the Y axis, review the diagnosis # 97 bit 4 (* ITY) = 0,
Check electrical circuit and are pins that are not...

hello all, I have the same problem with a 4-axis cnc bridgesport with Fanuc 6M control, I can move the X and Z but I can not move the Y axis is blocked could you help me?
I set the diagnosis # 97...