Hello Röder controller users
Who is using this option to created the necessary accuracy on the machine.
And thereby use also regrind tools even though the present CAM program was calculated with...
Type: Posts; User: Take-it-easy
Hello Röder controller users
Who is using this option to created the necessary accuracy on the machine.
And thereby use also regrind tools even though the present CAM program was calculated with...
Hello Elmoh!
I mean the program RMS edit.
Röders has offered it due to our demand for shop programming.
Then we found out that there is a better editor in that program than the one we work with...
To all Röders controller users!
Who has tested this new program or paid over 4000€ to use it permanently!!
We got an offer for the editor 150€, the simulator with cycles 700€ and the complete...
To all users of Roeder's controller!
Our versions 3.41 and 3.60 are preset with 16 measuring points for the "auto step edge" (automatic steps to measure the cutter corner radius).
Since we do not...
To all Roeder controller users!
At the beginning there are 3 values in the neutral point table (X,Y,Z).
Then there are 6 (turning, twist and inclination angle).
When the part is down and the...
To all users of Roeder controllers!
When the desk is overloaded and you need to run several parts of a series – then it’s necessary to switch off the breakage control so that everything is running...
To all user of Roeder control systems!
How long are your tracer pins?
Has anybody experienced problems or negative aspects when calibrating or presetting longer tracer pins?
The normal length in...
To all Roeder controller users!
My first impression of that controller a couple of weeks ago immediately imposed the following question on me:
Is it possible to process a work piece without any...
Hello Elmoh
I would like to work with the sister tool- however nobody before me has ever worked with it.
So my question:
Does the sister tool gets exchanged only through a new tool change...
To all Roeder controller users!
How can you see the capacity utilization of the spindle power and the drive axes during the operation.?
To prevent misunderstandings:
I know the load indicator...
To all Roeder control system users!
I am working with CNC machines for 22 years now and I found answers to many problems and questions- but with the Roeder…?
I don’t mean to talk bad about the...
To all controller user!
I am working for a few weeks now with a Röder controller and often write little errors into the command files because everything is still so new.
Now I have discovered a...