Search:

Hi Filusico,
To tell you the truth, I got fed up with trying to get the Novusun working. After about a month of trying all kinds of tricks, calling people, and getting no help from Novusun, I broke...

HI w7owc,
I don't have any computers left with XP or even Win 7 on them.
After trying for more than a week with every trick I could find, I gave up on the NVEM as a waste of time
Got the...

HI Kindlar,
NETSTST -R is NOT recognized as an internal or external command in my Windows 10 cmd prompt.
Any other suggestions??
Thanks Jeff

Hi All,
Just to complete this discussion.
I am SCRAPPING the NVEM do to lack of support, (sent emails to 3 different sites) with more than a week between them. NO response.
No connection method...

HI David,
One last ditch effort with the NVEM.. Getting a crossover Ethernet cable tomorrow. If that doesn't do anything, then it's the 400ETH. Since this is my 1st CNC venture, I believe that...

HI David,
It looks like the UC400ETH could be a good alternative. Found it for $160 on Amazon. Where did you see it for $140?
The HBB2 breakout board is $50 which is pricey, might wind up...

HI David,
Changed the IP to 192.168.1.17. Then to 192.168.1.50 Same results. I have never gotten the device connected msg. The computer is directly connected (straight cable) to the NVEM unit. ...

HI David,
I was using the V2.0a DLL, but went and found your NVEM_F copy. It works the same as described above.
I also tried the "driver test" pgm that's in the MACH3 dir. It says "no driver...

HI David,
Thanks for helping me.
In ports & Pins, 3 axis are enabled along with the spindle. Step port & Dir Port are set to 1's.
None of the axis change when putting in G code on the diagnostics...

HI Guys,
Just to add to the mix of issues with the NEVM, On the MACH3 diagnostic page, my PULSE FREQUENCY shows as "EXTERNAL" and I get no response from any of the steppers or the spindle. Does...