Search:

Hello Cryptodecals,
For the most part yes. What I have gathered though you may have used either the 4000, 6000 or 7000 files or a combination possibly. If you have used the original install disc...

Hello Cryptodecals,
Oh well it is not as easy as I had hoped. Usually for some time savings I would swap the Y drive with the X drive and see if the condition follows the drive. If not the circuit...

crypto watch the fault light on the Y axis Gecko. Furthermore the 6000 outlet is rated over 20 amps. The 4000 (and last revision 7000) was only 7-8. ping me via getcnc.com if further assistance is...

From experience I suspect the Mach3 pulsing engine is corrupted.
The quickest and least time consuming way to determine this is a clean re-installation of Mach3.
If you have not done this before I...

This is Frank Portulano formerly of DynaCNC now DynaCNC Plasma Router Spindle Laser Products Technical Assistance and Consulting. I am proud to announce the launching of retofitting kits on all...

Lowpull,
Sorry I have not seen this till now.
I have three of the 4000's all of which I replaced on the DynaCNC machines with the 6000 to correct the shortcomings the 4000 has.
In your router...

Well Driller,
I am the original in house engineer for DynaCNC of the 4000. When we experienced your condition the encoder connections at the servo was approximately 75% of the time the cause. The...

LAConcepts, all to often that is a EMI noise issue. In the application of an MP1000 this is suspect. It is possible there is the requirement of a torch manufacturer isolation board. It is slightly...

Hello Guys,
After meeting with the majority of those I could I have to say it was a tiring 12000 miles and almost 15 stops. I met a lot of good men and hope to meet more. My visit with Tom was...