Search:

Ok, I changed board. Using a standard chinese 5 axis lpt and UC100 USB , I have wired all Alm+ together to estop. All Alm- to Gnd. It works properly. Please moderator should change the board in the...

Thank u for reply. tomorrow I will try . Anytime I think I will go with cncdrive UC300eth and UCCNC cause this chinese board is not responsive in jog , not enought.

Hi.
I have 2 drivers HBS860H. I tried to connect alarm+ from one driver to the Input 1 of the controller, then Alarm- bridged with alarm+ on the other driver and A- to DCM (gnd for24V). I added a...

I just want to give a contribute telling who has the same problem that I have solved looking at the encoder wires colors.... there were an error in the sequence....To understand that, I have taken...

I just want to give a contribute telling who has the same problem that I have solved looking at the encoder wires colors.... there were an error in the sequence....To understand that, I have taken...

Hi dear, have you solved? I bought the same kit and i can't move motors. I regularly use open loop systems, now I don't know how to solve this issue

Hi everybody, I have a similar issue with 12Nm hybrid and HBS860H.
The motor runs for few steps with noise, then red light on the driver flash. Can anybody help me?
...

Hi all.
I have a Burny 2.5 plus and I noticed the same problem.
It goes to the switch displaying error path.
Any solution?

Hi all.
I just installed a new machine from China with n.2 Reci W6 tubes.

I'm concerned because on the first mirror I see a big circle/ring. About 5mm diameter.
Laser is new. I'm waiting also...

Hello, Merry Christmas to Everybody! I write from Italy, my own goal is now to design and build a 3 axis cnc router. I'm thrilled... "cnczone" is a an amazing place!