Search:

reskinner? Any ideas? It's almost as if the amps are not even being turned on.

Already tried that. The machine that is 5ft away runs just fine.

208vac input all three phases. 120psi to the regulator.

208vac input all three phases.

On initial power up wherever the selector knob is for jog, X,Y or Z it gives an alarm. If you move the selector to a different axis it will alarm out that axis. Screen message amplifier fault. Point...

So after doing everything I could think of and following all recommendations. I still had the same problem. So, decided to start from scratch. IT"S FIXED I found that the J10 plug was moved up a row....

It does not change on the ds screen.

I never see it change states on the DS screen. It must however be seen because it will rotate the spindle until the magnetic is under the switch and stop the spindle then fire the pin. As soon at as...

I have tried 2 new switches. Same issue, the spindle rotates and then the pin comes in and releases. This machine does have rigid taping option. removed the air line for the pin and held the pulley...

The switch does not switch when the spindle is rotated. The gap between the pulley and the switch is .011". The switch side wires are blue, brown, black and the machine side is red, black, clear.

Spindle orientation factor set to three. Watch video for better explanation of problem please.

https://youtu.be/zjdHDS8nYW0

It was purchased used. The current owner said he had to replace a card and input the parameters. But if you look at the door it says it should be a 10k spindle and the pulley looks to be from a 7500....

I have a 4020A with that will not orient the spindle. The spindle reotates and the cam lock fires and releases. I am not sure thie machine has the right settigs in setp. It has a 7500 rpm spindle but...

I'm looking for some help. Is anyone running a vertical mill with a Fanuc 31i and a tilt rotary doing 5axis machining. Not 3+2 full 5 axis.

I'm looking for some help. Is anyone running a vertical mill with a Fanuc 31i and a tilt rotary doing 5axis machining. Not 3+2 full 5 axis.

I'm looking for some help. Is anyone running a vertical mill with a Fanuc 31i and a tilt rotary doing 5axis machining. Not 3+2 full 5 axis.

This machine is fantastic other than full 5 axis contouring. It seems as though the TCP G43.4 is set up incorrectly. Physically the tilt/rotary is set up as a B and C axis. With a test program loaded...