please send me a copy [email protected]
Type: Posts; User: tuanpq
please send me a copy [email protected]
Floppy usb emulator for read is easy but for write is difficult. So I think that, the problem is in usb emulator.
Sent from my iPhone using Tapatalk
You should use usb to fdd ide converter. You must have electronic skills.
Sent from my iPhone using Tapatalk
Remove it from back
Sent from my iPhone using Tapatalk
BL motor is synchronous motor.
Sent from my iPhone using Tapatalk
Master board error
Sent from my iPhone using Tapatalk
I have makino professional 3 MSA50 lost parameter. Anyone have the parameter. Please help me. Thank you in advance.
Sent from my iPhone using Tapatalk
I think that it have no error but it is no good.
Sent from my iPhone using Tapatalk
Check 24v power supply.
Upload picture of led light in pcb of T-2
Sent from my iPhone using Tapatalk
I used to do it with hardware. but I don't remember it for a long time.
Sent from my iPhone using Tapatalk
I can fix it.
Sent from my iPhone using Tapatalk
you seem to have checked all of them . Did Your machine reloaded system software?
Sent from my iPhone using Tapatalk
Reload software
Sent from my iPhone using Tapatalk
You must buy same encoder because your motor have hollow shaft. Screw move through motor.
Sent from my iPhone using Tapatalk
What kind of machine. Your encoder is high speed and high resolution encoder. This encoder is rare.
Sent from my iPhone using Tapatalk
Can you take picture of motor and encoder?
Sent from my iPhone using Tapatalk
You check email
Sent from my iPhone using Tapatalk
This is what I think. Original your machine use master pcb same as my machine. But your machine is rebuild with other master pcb so you should find rebuilder
Sent from my iPhone using Tapatalk
Your master pcb is not for Fanuc 0-mate. it is rebuilded. my machine master ocb is in picture
463486.
You replace IO board
Sent from my iPhone using Tapatalk
It has T3
Sent from my iPhone using Tapatalk
TMM2089P-45 4 ICs in red circle 459132
you can replace by MB81C79A-45P
Edit #1=#4014
You copy macro from other machine. So if you want to run on your machine you must edit macro
Sent from my iPhone using Tapatalk
Fanuc 18T use EPROM to store PMC ladder, so you don't edit it by Ladder III software. you can read it by Ladder III sofware.
457940
Master board error.
Sent from my iPhone using Tapatalk
Do you try increase speed slowly from 0 ? How much rpm when over speed error appear?
Sent from my iPhone using Tapatalk
I think when you connect cable, phase is not correct.
Sent from my iPhone using Tapatalk
Do you disconnect u v w cable. If yes then you check u v w cable
Sent from my iPhone using Tapatalk
Can you help me parameter of Mazak slant turn 40N ATC m/c my email: [email protected]
Sent from my iPhone using Tapatalk