Hi all,
Got a bit of a problem, I have installed this controller and all is working.
When you move the head with the key pad, the head moves in the correct way.
The trouble is that it thinks home...
Type: Posts; User: chippypah
Hi all,
Got a bit of a problem, I have installed this controller and all is working.
When you move the head with the key pad, the head moves in the correct way.
The trouble is that it thinks home...
A host of problems, in all the engineer's came out but did not understand what was causing the problems.
So gave up on them, changed power supply and tube and controller.
Also had to replace the...
Sounds like a Mantech machine, sorry to say there engineers are not very good.
I have one of there machines, and have changed all except the chassis and now have a cracking machine.
If you get stuck PM me, and will give you my number.
Cheers
Pete
Must be built into it, is there any info on the board make number.
Have you got any pictures of the layout at the moment, changed mine over over a year ago and is so much better with new controller.
Your old board would still have used stepper drivers, the stepper motor is connected to the driver and the driver to the board.
Try lowering the speed and see if that helps, looks like in picture 3 you did not set the origin.
Any one no how to wire in a remote test fire button, the control board is a MPC6515.
I no you can do it from the control panel, but when adjusting mirror one it would be handy to have a remote...
Wired as per these instructions.
Cheers
Pete
Thanks for the reply's, checked the fuse and it is OK.
Cheers
Pete
Hi All,
Just got my upgrade 100 watt tube and power supply, from Coletech but the power supply is not working.
Can you run a 100 watt tube from a 60 watt power supply without doing any damage to...
Thanks for that.
Cheers
Pete
Hi All,
Can anybody give me the information on how to wire in a pot, to adjust the power on my laser.
Cheers
Pete