Search:

You should be able to remove the oil feed line and count the drops per minute. The spindle manufacturer should have a manual with the info for your paticular spindle. There will be an adjustment on...

It's most likely no more than a malfunctioning pressure switch. If it is functioning it should keep the signal to the control all the time. Good luck.

Intermitten things are usually some mechanical device malfuctioning. Electonics usually burn up and that's it. Good luck.

Ram parity error is usually a bad mother board, sorry it's an expensive repair.

In my experience you have a dead motherboard, sorry gonna cost you.

Just hold it close as you can. If you don't have reamers, drill about one size under then follow with the correct size. Walah size is dead on!

Ron,
You may be over thinking this. Just go by the bearing manufacture's recomendation. Old bearings that feel gritty, Idk. Clean them, put good grease, hope for the best. If your not machining very...

Steve,
At the bottom of the (CRT) there should be (soft keys). They are situated left to right. On each end over keys Im assuming that would be your up and down pages you are refering to. When you...

Try switching to MDI mode find pwe parameter change from 0 to one. This will cause am alarm. Now find the (pcprm) soft key. Then you will see the selection for T/D/k/ and another letter. Select that...

I have had this problem. An operator crashed one of our lathes pretty hard. Took a bit of trouble shooting. I found one of the Honda cables was jarred loose where it hooks to the main board. Try...

thats helpful information. thanks