Search:

Thanks,
Luckily mine is in a replaceable style holder. I have a battery on the way. I went thru and took pics of the parameters and I think I have the factory floppy with backup files.

Lucked across this while searching this forum. I have a keyboard on the way. I need to search cmos battery repair now. ...

The issue just occurred today. I attempted restarting and reseating the display connections. The screen displays in full during boot up. Then goes to partial screen for Operation. Pic attached. Any...

Thank you very much ZZZZ. I will do the checks described and report back.

I put an indicator on the end of ball screws and they do not move when I push/pull on table or when I jog the axis.

I have a milltronics partner 3 with centurion 6. I was indicating a part in today and noticed that the digital readout can change .001-.002" before indicator showed movement. This is in the x and y...

Thanks for the replies everyone. I got the mill running. The main relay and the servo transformer were also getting a leg from L2 as well as one of the other legs since they are 240 single phase...

Thanks rl49, I hope that is it. I have attached another pic with numbers showing where each of the legs is wired to. My L2 has several leads running off of it and one of them is to the transformer...

I just got my "new to me" mill set up in the shop today. Partner III with Centurion 6 controller. I am in need of help concerning the connection to my RPC. I am really not sure which L# to put the...