After roughing with end mill, use a ball nose end mill for final pass.
Type: Posts; User: knowell2
After roughing with end mill, use a ball nose end mill for final pass.
Click on toolpath tab > machine relief > go to top of page: Area to Machine, click on Automatic boundary. This will allow you to machine only the relief model. This option might not be available in...
link to Machine Tool Warehouse:
https://www.machinetoolswarehouse.com/xcart/home.php?cat=309
The material allowance is set in the Z slice on the Z Level Roughing toolpath. Enter a value say 1mm and it will leave that much allowance between the material and the tool. Click apply and it will...
Once you have created your toolpaths, click: Toolpath Operations > Toolpath Summary. It will show the estimated time needed to finish the toolpaths. Hope this helps.
Is your website up and running? Link...? Tnxs
Outlaw,
Try http://www.hobbymetrix.com/scales/digitalscalemain.htm
They have different sizes to fit your mill. I do think you still have to provide the brackets for the scales.
Good Luck
Thanks Graeme for taking the time to post the pictures of the oil seals. I'll check my local bearing supply store and bring the pictures for reference.
Graeme, my RF 45 is experiencing the same problem. It is leaking oil in the spindle. Do you by have the specs for the oil seals? I want to be ready when I take the whole assembly apart. Thanks.
You can check out this site. It has a lot of info on using a router to mill out guitar bodies.
http://www.cncguitar.org:7171/
salamat
I have successfully used this speed control board from CNC4C:
http://www.cnc4pc.com/Store/osc/product_info.php?cPath=25&products_id=58
Spindle is the 1.5KW model with the matching Huanyang VFD....
Don't have the spindle yet but you might want to check out PD013 parameter reset in the manual.
Under Config -> Gen Config, upper right corner set debounce interval to 2000
I was at the MOA trade exhibit last week and there was a laser engraver offered for sale that surely fits your requirements. You might want to check out this company: Graficad Creation, Inc in...
Great little machine you have there Jason. Kudos, nice work.
Hope you don't mind me asking but how much did the Kavo spindle and controller cost?
Keep it the nice work.
Noel
Any suggestions where I can find extruded aluminum in the GTA preferably near Markham. Thanks in advance.
Noel
Once you have your toolpath, go to toolpath > save toolpath. A window opens. Click on the toolpath you created on the left side. Click on the arrow pointing to the right. Your toolpath will now be on...
Hi everyone,
Just recently joined the this fine group of enthusiast and I was wondering if anyone can offer suggestions where I can get linear rails and ball screws in the GTA area preferably in...