The free version of Fusion 360 doesn't include 4-axis machining anymore as far as I understand.
Type: Posts; User: hof
The free version of Fusion 360 doesn't include 4-axis machining anymore as far as I understand.
I'm not familiar with Mach3 which I guess that you are using. Perhaps it's integrated with the other settings.
In Mach4 it's under config > control and the configuration looks different for each...
I think that's normally referred to as "back-off"
All controllers have their own homing routines but it's not uncommon to approach homing sensors at speed and then slowly back-off again until the...
I don't think soft limits make a difference.
I'm guessing the homing order is missing. The default homing order is 0 which disables homing for that axis.
Set them to 1 or 2 or whatever order you...
Hi,
A few things..
Does it make a difference if you move off all the limit switches before homing?
Have you specified homing order for each axis?
Can you take a screenshot of the...
I'm not familiar with your controllers but it sounds like your steppers are stalling.
Try lowering the acceleration in the motor configuration. If that works, work your way up again to find where...
I don't know what the homing routine on the ESS looks like but I have solved this differently on my 3040 which use limit switches for homing. I use the Darwin parallel port plug-in and it has no...
Limit switches should be normally closed so that they would trigger if the switch would break rather than just silently stop working.
I have added limit switches to my own 3040 using the same...
Hi all,
Brand new user - long time lurker from Sweden.
I'm a maker who mostly have played with electronic circuits and software. I'm also a frequent 3D printer user. I'm building my designs in...