hello, i own a 100watt co2 laser and i was thinking to upgrade the machine to cut some thin metal with it. now dont know much what should i look for , any suggestion what to buy for an upgrade to ...
Type: Posts; User: magnetos2010
hello, i own a 100watt co2 laser and i was thinking to upgrade the machine to cut some thin metal with it. now dont know much what should i look for , any suggestion what to buy for an upgrade to ...
thank you. for the info. works now.
hi, solved . the tech told me by Skype what wire was in the wrong place, works now . Time to carve parts. thank you.
the machine its Artech 1325R, still await info from the Chinese engineer ???
hi, that's what i was thinking at first when i saw the L1 2 3 on the top of the screw-bar but the tech who sold me the machine say to connect l1 and l2 to power up but its not ..
at top of the bar...
Hi, no info came with it, ask saller still watting.
Well my main panel have the neutral and ground in common.
I use a 30amp breaker 2 phase to fee the cnc controller.
Attach images.
When I...
Ok, I check the manual and say , one analog 0-10v Vso , I try to enter the pin number that I see on the manual but the voltage stay high. In the motor output if I set high dir/step on the spindle...
hi, yes i had the spindle pulley at wrong speed , fix it to 24000. and now its setup on pwm control, i disable motor output spindle , i still read 10v volts on the pins gnd1/VS0 of the controller. ...
hi, may ask what setting did you use to send signal to the vfd. i have a similar controller different vfd but the pin and port number should be the same. thank you.
hi, did you figure out how to make work the vfd with mach3, i have the A2-8022 Vfd model but i have a different controller "NVUM-usb".
Did you change any setting on your vfd ,wiring.
thank you.
hello CNC User, i am trying to setup a new water cooled Spindle and a Vfd.
spec:
2.2k 220v motor, 24k rpm ,400hz , 8.5A
VFD , its a A2--8022 , made by Isaco power control tech. 1 phase in , 3...
Nice work, I have a x2 , like you a start it but never complete the project :giggle:
Cheers.
Sent from my Mouse 3G
hi, do you use hobbycnc board to test foamworks, if yes what setting did you use to controll the bard .. can you take some picture of the setup. i can't get it right pin port setup or the motor speed...
hi, what software did you use to controll this board. do you still have the setup to controll it . is been 6 years that i am trying to use my cnc foam cutter .. never got to work.
does anybody as a detail of foamwork pin port for hobbycnc rev.0 foam cutter . i would like to try since 2005 and still stuck .. not cut yet. i use 3/8 16tpi rod.
i will try different software if i...