Thanks for you help,
the stylus is 100mm long. But cf this manual in french (proivided with the VQC) it seems to be fully automatic.
Obviously I need to place it in the good pocket on the rotary...
Type: Posts; User: eltorio
Thanks for you help,
the stylus is 100mm long. But cf this manual in french (proivided with the VQC) it seems to be fully automatic.
Obviously I need to place it in the good pocket on the rotary...
Dear All,
I'm back in discovering my Mazak VQC20/50b fitted with a CAM-M2 controller.
i've just repaired my automatic tool measurement unit and the tools are correctly measured.
So i continue...
Thank you JAO, I've just send you a private message
Hi everybody,
I continue discovering my Mazak VQC20/50b
I did not came here for 1 month because, I wanted to test the automatic tool measurement for the first time! With the help of Eliseo I...
Thanks a lot
Dear all,
On my new VQC20/50B I've got an alarm saying that the spindle oil level is low.
So I read the oil reference on the machine, I bought it and now I look everywhere for finding where the oil...
You may have right I zoomed on my picture (wich is at least 3x more clear that in the machine) it seems to have 2 spacers, perhaps it is only an adapter screwed on the original DB25...
Tomorrow...
Dear All,
On my new VQC20/50, the original DB25 female DNC plug has been replaced by a RJ45 one.
Since there is no official standard for cabling EIA-232 on RJ45. Does someone know the original...
Thanks... I've found I think the most stupid problem.
After understanding how the "home" process works. I disassemble the Y axis protectors and inspect the screws, the servo, the belt... I move Y...
Thanks again Eliseo,
I'll first try to find the Y axis position switchs, I don't know where are they but I'll investigate this evening.
With Eliseo's help (he send me the complete CAM M2 operator manual),
I find the english message equivalent to french "ecart trop important axe Y"
The english error is "SERVO LAG EXCESS Y AXIS"...
Dear All,
As I wrote in a precedent post I bought a Mazak VQC20/50 controlled by a Mazatrol CAM M-2
My problem:
When I try to home Y, after moving Y+ by impulse, I finish with a message:
"2...
oups. I cannot pay for a Mitsubishi tech.
I'll open a new thread for that for putting the good title.
Thanks again Mr Mazak
Mr Mazak you are a precious member!
I succeed to home X and Z but on Y I got an error message "2 ecart trop important axe y" wich can be translate as "2 gap too large Y axis"...
THANKS.......... a lot!
Now I think I need to go to "home 1" in fact as you can see in the picture it asks me "RETOUR A ZERO" ("return to zero"), but I cannot change the home position it is still...
Hello everybody,
First:
Thank you for all the members of the forum who post. I've already found plenty of information, and sure I'll need it for correctly using my new game.
Second: promise...