My HDD is dead (Seagate 2.11GB 3.5 inch IDE). I can order a new IDE hard disk 40GB on the web. Can I install this?
I don't have an image of the dead HDD.
I have a backup on TNCremo...
Kind...
Type: Posts; User: peco2002
My HDD is dead (Seagate 2.11GB 3.5 inch IDE). I can order a new IDE hard disk 40GB on the web. Can I install this?
I don't have an image of the dead HDD.
I have a backup on TNCremo...
Kind...
Hi,
My HARD DISK is dead I believe. If I put power supply on hard drive is not turning anymore so I can not clone :(
Hard disk is ST32122A
Heidenhain:
Laufwerk
Id.Nr. 329 660-02
S.Nr. 8 351...
after restoring backup machine is working again.
kind regards pedro
I found a pdf on this site about alarm 401 from congchipham in 2008.
With that pdf I followed the steps.
Was a problem with the JX5 pins (they go in my machine to X32 on main board)
bad...
this is the fault code.
alarm 401 on both x and z axis
anyone have experience with this?
kind regards
Hi,
I have a servo alarm on my harrison alpha.
I don't have much experience with this.
Can somebody advice me what to do?
pictures added
thx for reply
in attachment you can find schematic of x, y and z axis..
kind regards pedro
Hi,
Are there limit switches for the axis or are they integrated in the glass scales?
kind regards
Hi Servtech,
I went to local electronic shop for test.
There was damage to spindle drive and power supply.
I mounted everything back together.
Power supply shows red lights (power fail and nc...
thx for reply!
how can I check?
I took off the metal plates that give the power to the other drives on top of the power supply, but short circuit happens still...
Hi,
I have a DMU 60, and I can not start the machine up anymore...
I heard a loud noise and the fuse jumped to off.
I restarted but again loud noise and fuse off.
If I checked from where...
Hi all,
I bought a 2ndhand DMU 60e.
I started the machine up and the toolchanger is not working properly.
In video you can check the problem. The Tool changer is taking the tool out of the...
Hi,
I am thinking of buying an Harrison Alpha 400 Plus.
There are 2 floppy disks with it, ALpha link 3.0 version and also update 3.1 version.
these software looks really old and not easy to...
Hi,
Is it possible to make a datum table in TNC155?
I am using fusion 360. I use postprocessor for TNC155. In fusion 360 I can select numbers for Datum.
kind regards pedro