Search:

Pm John here he is very helpfull , should hook you up with books or some info.

Do You have separate driver for each motor ? Or there is 3 in 1 driver for all the Motors? We want to do same thing with vm50 but can't find any info about the Asus drive unit and if it wasn't bad...

My Hitachi vm50 got Orange screen , machine was staying idle then suddenly black screen appeared and everything was shutdown. Is it something with graphic card ,or LCD ? Or its the NC Control that...

Few days ago got one scary situation, after probing part on vm50 when I hit cycle start Z Axis instead of going on to Z0 g28 , dropped into the part like it's freefalling , immediately pressed the...

Hi, where in the vm50 I can find the servo endcoder batteries ? I have attached the cabinet photohttps://uploads.tapatalk-cdn.com/20180516/784d4ca63891a1728acb9c476336f78c.jpg

I have vm50 , could You share the procedure if its the same ?

enabling drip feed in Hitachi Seiki mill

I can tell You how its done on vm50 seicos 10l is your any similiar ?

Recently I have encountered a problem with rs232 communication , I was able to send files from machine to pc but not other way. To Fix the communication I have resoldered new mc1488 and mc1489 on pc...

Is there a way to expand somehow memory on this controller (lambda 10 vm50 machine, but on motherboard IT says vm40) ?, Right now it does have 1000m of memory which is roughly 400kb.I tried running...

Than You very much John, I found the switch and corrected it with M codes. I have one more question, is it normal that the machine does have the Y axis + towards the operator( Y+ south, Y- north) ,...

Here's the APC panel photo, only those buttons385690 , I will try the M998 code and report.

EDIT:
I tried the M998 and M999 but is does say that referencing is incomplete. I looks like I will...

Hmm, I didn't saw a button like that on the control panel here are pictures of the control panel
385688
When I try codes for pallet clamp M90x it does nothing, but says that I need to reference...

Hello, I have a problem with my vm50 (lambda 10m controller) during pallet change the emergency button was pushed . Now to do anything I need to do the referencing of all Axis , but the Y Axis is...