These parts are no longer available.
Type: Posts; User: Makrep
These parts are no longer available.
I presume this machine is either a FX or CX machine? If yes, please go to the maintenance alarm screen and look which "U" alarm is in the alarm memo section, this will be the alarm which caused T217.
I have switching units, servo amplifier, complete CNC card bucket, Oscillator unit, DC unit, resistor unit, MIFC unit, replacement TFT screen available, all from working machine that is no longer...
Hi which country are you in?
To get maximum cutting speed, you have to have approximately 0.012" of clearance between the upper head underside of the nozzle and the workpiece. The clearance of the lower head and the underside of...
I would think you should rough cut at approximately 6mm/minute with .010" wire, so that would be approx 14"/hr in good conditions. I would not believe the Agie user!!! That equates to 11mm/minute!!!!...
Hi there,
1) do you have 2 round gauzes covering the drain holes? If yes make sure they are cleaned back to stainless steel.
2) check the drain flaps are closing properly, and no water is leaking...
Is your machine a straight FX machine or is it a FX20K machine?
Check the 6 avr's on the back of the sub unit.
On top of the generator is a cover covering fans and some load resistors, check the resistance of the 2off 4ohm resistors, they are wired in series so should read approximately 8ohms. Sometimes we...
Please send a picture, normally the X also has the Y axis on the servo drive, we may have a spare from a scrapped machine.
Those 3 connectors go on the Servo amplifier that is behind the panel on the right side of the controller, you probably already connected the motor output and tacho wires to the bottom of the unit....
It could be the fuse on the UPS pcb, do you know where that is situated?
do you have a seal plate cleaning program on the pack disk? If so load that and run that program.
We just scrapped a Mitsubishi CX20 and have a lot of spares if anyone is interested.
What happened with this machine fault?
There should be 6 small AVR's on the back side of the sub unit, check them to make sure they are all ok.
To see if the contact goes away.
Put the machining cables back on and then remove E and W from the terminal strip on the front of the SUB UNIT. Is your machine a FX20 or a FX20K?
It could be that the small motor that cuts the wire when it has broken between the guides is down to earth, this motor can be found on the AF unit under the grey plastic cover, just remove it from...
You say "when we move the machine" the contact light comes on? What happens if the machine is not moving and you turn wire on? does the machine have auto wire feed?
What is the level of system software, it is the BRD no on the 1/3,2/3,3/3 disks.
Can you put that in English please? I think it is something about being unable to load software?
The problem is not necessarily the bigger particles, because the more you get, they themselves act like filters when you get lots of them together, the problem is with the small particles, especially...
We are service agents for Mitsubishi here in the UK, and i can honestly say that if you keep them clean, they are the most reliable series of machine that i have seen so far! And i have worked on old...
Awesome machine, so reliable, wicked threader! Go for it!!
Does this machine have auto threading? If so I think the wire connects to the plastic cover for the collection rollers, inside this cover is a stainless sheet of metal and the wire takes the...
Is there an alarm light on, please go to alarm screen (display,5,5) and maybe take a photo of what is on there.
I am the UK service agent for Mitsubishi and in the past I have worked for Agie/Charmilles, As far as we can see and our experience of the MV series, it is awesome!! It is not so good for us, because...