Search:

Hello mapemera

Have you solved the rumbling problem with replacing TB2?
Thanks.

Yes,
machine has come from UK in Serbia and original manufacturer is from Spain. Manufacturing quality of boards is quiet good but there is not any name of manufacturer, just serial (PCB...

181040181039181041

Hello gays

Is there anybody who can recognize boards from attachments. This is power supply board and one of three servo boards. I would be grateful if someone could give...

Hello :wave:
Is there any who meet Kondia K76 machine with Micon cnc controller ? My problem in fact is servo controller (3 axes board plus power board) from unknown manufacturer. Please for any...

It is probably problem with monitor only

Ideas of Al The Man are preaty good. Also , what about indication at LED's . RF and RS are foer enable, MR1 and MR2 for direction, BB - ready etc. BS indicate fault conditions.

Hi gay's
Is there anybody who can help me about analisys I/O board M022 for Operation Panel. Problem is machine behavior: without any operator action mode machine are changed, manual spindle speed...

Is there any recomendation for commercialy BTR. Some low cost solution?

Hi gays
Is there anybadi who knows way to use connector with remarks RS232 at interface PCB at control system OSP3000. And way to load part program from PC to control . Thanks

Hi guys
Is there everybody who now why hapaned with Glentek GA4568E Z axis amplifier on VMC 904-1. Z axis dont move, and on "fault" pin (No. 6) of amplifier I measure 5.5 V. At X and Y amplifiers...

Thank you Andy
I will try this ASAP and write result to you.

Hello
Are there any comment about this error during butting conntrol Fanuc 15 on
SL-25 lathe. Is there "medicine" for this behavior?

Hello ndp
I'm prety sure that you have some proximity switch for tool position codding bad, (or unadjusted, if you lucky guy) and an original spare is wright solution. I was tryed in past time...

Hello ncmas
Can you sending me wiring and parameter's detail's please for GE control. I have not DNC control available at the moment, but I hope that i can realise file transfer. Am I wrighte or...

Hello Ozgurm
If you find solution, share it wit us , please. Wiring and parameter detail's. Thanks

Hi guy's
Is there anybody who now way to compensate axes backlash in General Electric MC2000 control. Machine is Wadkin VMC 6-4. Where I can find parameter list and haw I can edit parameters?...