Hi All , I am seriously considering using the DMA860E . It seems Ideal for my application . I going to retrofit a Bridgeport Boss 5 . I have 3 of these machines and finally tired of changing...
Type: Posts; User: tapburrbit
Hi All , I am seriously considering using the DMA860E . It seems Ideal for my application . I going to retrofit a Bridgeport Boss 5 . I have 3 of these machines and finally tired of changing...
It worked out fine. I bought a puller from someone on Ebay. It is a three craw puller that is adjusted with spring pressure. Only negative comments would be that the your stock has to be extended...
It was a simple error in my programing.... I mixed up G94 and G95 in the program.
G94 is inches per Min and G95 is inches per Rev.
I've had two of these lathes for quite a few years now. One with a air bar feeder and one setup as a chucker. I set the chucker up with a bar puller today and got it to work, but I'd like to get the...
Here's what I found to get the machines to run all day again. I Ran the two machines for a few days with open control cabinets, As the began to show problems shutting down , I started to swap...
The fans are all running fine and there is no problems with the spindle motor or it overload.
Hi all, Maybe someone else has experienced this problem with their old Boss cnc to. I have 2 machines that are giving me problems. One will only run for 3 to 4 hours a day and stop any where while...
Hi All,:wave:
I have had quite a lot of experience tapping and speaking with others about their tapping problems. I agree with floating the tap a little even when rigid tapping. It really helps...
Hi All,
I have an older Bostomatic 312 that is starting to give me problems. It has an SPCII control with a Ampex cpu . I believe the problems I am having now have to do with the power supply in...
No , I meant below, the directory you want to delete. If you were above, in my mind you would be in a sub directory of the one you want to delete. That wound''t be allowed , the directory must be...
Hi, Bob
If your already in Dos and one directory below the directory you want to delete, the command is... rmdir_directoryname . the _ is a space.
David N
I spent a few hours yesterday homing the machine and testing all the limits over and over again. I did notice that after the machine homed the machine position would register .0191 for B axis not...
I see you guys are talking about Kia's . I have a Kia SKT15 lms and I am getting a Fault ( 500 over travel : +B ) . after the machines Homes. Does anyone Know what the problem might be. Last year...