584,842 active members*
4,196 visitors online*
Register for free
Login

Search:

Type: Posts; User: GCSRT

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    1,858

    Re: G code to cut inside groove

    Seems like you need to set your lead in/lead out correctly. Also dropping into a 1/4 hole with a 1/4 cutter makes it more difficult to get a nice ramping in ramping out.
  2. Replies
    6
    Views
    2,095

    Re: Confusing Tool Path

    I would use 2 axis profile rough using ramp for the outside dia, and advanced z level finish for the inside angle, selecting only the angled surface. I am not an expert though.
  3. Replies
    5
    Views
    2,712

    Re: Simple 3 axis flowline

    I meant to the After Dark page...
  4. Replies
    5
    Views
    2,712

    Re: Simple 3 axis flowline

    Do you have a link to that? I can't find where to post...
  5. Replies
    5
    Views
    2,712

    Simple 3 axis flowline

    Toolpath looks good, except the very outside contour that wipes out my whole part. How do you get rid of it?
  6. Replies
    3
    Views
    3,247

    Re: Mastercam X4 3d contour not following contour

    Hell yeah dude!
  7. Thread: reverse contours

    by GCSRT
    Replies
    1
    Views
    1,698

    Re: reverse contours

    Right click on "default chain start point" and pick "reverse direction"?
  8. Thread: 2021 Fillet help

    by GCSRT
    Replies
    3
    Views
    1,372

    Re: 2021 Fillet help

    Or a 2D swept...
  9. Replies
    3
    Views
    3,247

    Re: Mastercam X4 3d contour not following contour

    You need to program the center of your tool instead of the tip.
  10. Re: Gap between tool and holder in backplot and sim

    Thanks for the Quick Tip. Pretty sure my tool geo is correct. Here is a screen shot of what I get. The holder always says the same distance away from the tool. If I shorten the protrusion, the back...
  11. Replies
    1
    Views
    533

    Re: What's New in V33 ?

    Thanks! Check my post below.
  12. Replies
    2
    Views
    877

    Re: How to Select a Drawing in mcx7

    Sounds like you have to window each drawing and use "save some" to save 28 different files and name them 1 thru 28? Then pull up each drawing seperate, fit all and print.
  13. Re: Gap between tool and holder in backplot and sim

    Hope this works!
  14. Re: Gap between tool and holder in backplot and sim

    Version 32, sorry...
  15. Gap between tool and holder in backplot and sim

    So I made a custom tool and modified a tool holder. When I change the protrusion length, all it does is change the gap between the tool and holder. This won't work for collision checking. I am using...
Results 1 to 15 of 15