Search:

Well, I resolved it through the back door. Solidworks cam chooses a lead-in radius that is 54% of the tool diameter--should be no problem, However to fix the issue I used 105% of the diameter and...

I'm going a bit nuts--using the solidworks cam system and post processor on a delta 20 control. It has it's glitches but in general, they're easily correctible. Unfortunately, I'm mostly an...

I want encoders for 2 reasons.

For one, it makes me feel better. Sounds stupid but projects in the past were servo-based and I liked encoders knowing where I am (at least to whatever exent they...

I'm getting back into motion control after many (too many years) here and am in need of steppers for several projects. I've forgotten more than I learned in the first place so will start with a...

can't give any help on the drive end but a quick comment on the Taig couplers....I had the same opinion you have but found them to be perfectly serviceable and not nearly as bad as the first...

The last project was 12 years ago with a Kollmorgen (roughly 5 horse, 5000 RPM) servo set-up for a single axis forming machine...Since then, I've forgotton more than I learned so though it was better...