Search:

Hi,

I am new to this and I have run into a problem with touch probing after I have grounded my table to the ground pin.

My setup is that I have a power connection to the machine torch tip, and...

Hi,

I use a Masso G3 as my CNC board

I need some help with my THC controller.
The THC is a PlasmaSensOut from PoLabs:...

Hi,

Thank you both for your reply! I actually found the problem :D
I needed to connect the enable terminal (ENA) to the 5V terminal..
Did that and a green "active" LED lighted up on the board...

Hi,

Not sure which forum to post this in, so if this is the wrong one, I will apologize in advance and hope you will move it to the correct forum.

I am completely new to this CNC / Mach3 /...