my Arduino ide software serial monitor is showing like
firmware version : 0x0 = unknown
WARNING :Communication failure, is the mfrc522 properly connected ?
scan picc to see uid, sak, type, and...
Type: Posts; User: olaf123
my Arduino ide software serial monitor is showing like
firmware version : 0x0 = unknown
WARNING :Communication failure, is the mfrc522 properly connected ?
scan picc to see uid, sak, type, and...
Hello, I want to hook up a MPL3115A2 pressure transducer sensor and interface it with an Arduino micro-controller. But I have a question. I could set up the display and I can see it is working. The...
I'm trying to use 28BYJ-48 stepper motor with ULN2003 driver Arduino, i.e. move an object in one direction for a short time and then reverse it and then do a repeat while the power in still on. I...
I want to build an electronic level with MPU-6050 and Arduino. I have one of my MPU-6050's mounted on a breadboard and started the example in the library but the numbers are drifting quiet a lot...
Hello, I have a question. Could I use an Arduino Pro Micro (10bit resolution) with the ADS1115 (16bit resolution) to build a joystick (with better sensivity) that uses some hall effect sensors with...
Hello, I want to hook up a MPL3115A2 pressure transducer sensor and interface it with an Arduino micro-controller. But I have a question. I could set up the display and I can see it is working. The...
hello i am quite interest in the project about DDS AD9910 Arduino Shield Signal Generator .. I need about 2MHZ dual chanell square wave gen.. with3 function set freq, phase shift and dutty ( but not...
I'm trying to make my own Arduino-like microcontroller board. I have an application where I need to take sensors that provide 5 different types of information, and using a micro-controller transmit...
I am trying a simple program of fusion 360 CAM, but when running the program on my new SYIL X7, offset is set on top of the material in G54, but somehow my facemill, takes NO material during facing...
I had a cheap motor driver that I bought on kynix. You can see product details at ATA6833C - ATMEL - PMIC - Motor Drivers, Controllers - Kynix Semiconductor.
I was planning to use this motor driver...
I made a custom PICAXE-based PCB that integrates all of the components needed to program the microcontroller. I assumed everything was fine because I could use it to program under Windows just fine....
The Project is based on LV8727E IC from ON Semiconductor. The LV8727 is a PWM current-controlled micro step bipolar stepping motor driver. This driver can provide eight ways of micro step resolution...
Hi,
I am new to PIC18F66J94 Controller and trying to compile it in MPLABX but i am getting compilation error as following.
CLEAN SUCCESSFUL (total time: 143ms)
make -f...
Universal mobile charger
I made a mobile charger using 4mm MDF board. I already sealed and I was not able to disassemble and show you. I am going to explain how i did this...
...
Hello, all. My name is elsa and nice to meet you guys.