I'm in the process of building a new table and have been researching what controller to go with. I've built a few tables in the past and have used Flashcut and CandCNC (w/CCNC).
The biggest issue...
Type: Posts; User: OklaWelder
I'm in the process of building a new table and have been researching what controller to go with. I've built a few tables in the past and have used Flashcut and CandCNC (w/CCNC).
The biggest issue...
I'm trying figure out how to design a 4'x8' downdraft table. I have a 3900 CFM / 2" S.P. blower that I will use. I want to be able to cut small pieces without needing to cover the unused area of the...
I'm finally getting around to hopefully building a air bladder table for my machine. I want to build one that the table is deep and acts as the bladder, not a separate tank. I'd like to get some...
I have seen CandCNC's feathertouch system to use OHMIC. How come I couldn't just connect a wire from the Z home limit to the OHMIC clip and the other side of the limit to ground. Then the tip will...
Those of you building water pans that have the air bladder under the pan, how are you dealing with rust inside the bladder? What about the dirty water going to the bladder and sediment forming in the...
I have a small plasma table (4x4) that I built that has a water table. I looking to build a 5x10 and am thinking of making it a downdraft. I hate the mess with the water table. But I end up cutting a...