Search:

Please check you have the option parameter switched on 900 bit5

this is adapter i have used, and use original cable to Hard drive462066

Parameter setup looks very much like most Hitachi Seiki's
Hitachi do not use M code for tapping
Call line is G84.1 Z-14. R 3. (example) and ends with G80 as other drilling cycles

Never done that, dont know what changed internally in the drive, so cannot advise

I have successfully installed a CF card in a 15MB data server which I think is the same device, worked first time, used a 1GB CF card, so maybe check your cable/adapter

462006
as you can see in the picture
X20.7 needs to go off to switch off, so you need to check this input
also when KM5 is energised it latches itself on, so make sure ON switch is not sticking in...

normally some sort of door interlock fault, because turret will not index in auto mode if door is not closed

Hi
Problem always arises with 6096 h208 drive unit, the software version in the drive changed, so you have to have very similar serial no on the drive for it to operate correctly

There are no zero return switches or overtravel switches
Over travels are set up in the soft limit parameters

You need to reset your origin positions
par 22 bit 0= x bit 1=z

set...

I did training course at Hitachi in japan on super hicell
3 versions
1- 5 degree increment, these were first models, not many made
2- any angle clamp, but extra clamp into curvic...

Ive had the same problem on arrow 750
The brake in the z axis motor had failed (coil burnt out) test windings with meter
Because the motor is expensive I bought a cheap motor and took the brake out...

These are the sub programs called up by the omron controller, they are fixed in the motion controller and you do not normally require access to them
there will be a data table with all the load and...

I have just replaced the windings on the same type of machine, and have to remove the items you refer to.
the 3 pieces you refer to are an integral part of the locking nut and do not come out as you...

hello Jim
Go to the thermal comp page and at the bottom of the screen there is a function to disable it. press Y and its done.
the thermal comp page is on the system page F4

hope this helps

A PC card was shipped in every machine from Hitachi Seiki.
This card was in the cabinet and is needed to reload the ladder / params for powermate for the turret.