Search:

I got hold of the original parameters from japan and it seems to have solved the problem! Thank you for your help!

)

See pictures. Really starting to lose faith. I did notice that when changing pallets manually the pallet gets stuck, seems like X0 is not quite in the middle, might have something to do with it....

I’m checking now. In the LAD there’s a few lines relating to APC. APC front k, 2APC, M-APC, Special M-APC. No idea what any of it means though, except APC of course. Do you have a clue? Thanks

Yes i did. I finally got hold of the correct parameters! Might be slightly wrong as it’s for a different machine but everything seems to work except the APC.

M60 does call on a macro that i know works. But pushing the pallet ready button can be done whenever as soon as the door closes and a program is started. But right now the pallet ready button isn’t...

Hi! After a ram parity error i have now re-entered all of the parameters, macros and programs that was lost. But for some reason the M60 command will not work, i have noticed that the "pallet ready"...

I do have a printed ladder in the hardcopy but no PMC Parameters unfortunately.
I've sent you an email, thank you!

Machine is a Niigata HN 50B #25530

Seems i have not. I don't have any backup of these PMC parameters, is there any way to figure out what should be entered? Can't find anything in my hardcopy manual, might just be because i don't know...

Hello!

I have a niigata hn50b horizontal machining center with Fanuc 15-M controls. I've read through every post i could find on the subject and tried every solution suggested with no luck, so...

Will do, thanks!

Hi!

Sometimes our niigata horizontal machine center with fanuc 15m control enters single block mid program. Any ideas what might cause something like this? It usually happens when the machine is...