Hi
I recently purchased a 1986 Mitsubishi DWC110H wire edm. I got the machine set up and now it comes up with "WIRE CUT W7 NOT READY". From what I have read on the forum, this means the software...
Type: Posts; User: knightlord
Hi
I recently purchased a 1986 Mitsubishi DWC110H wire edm. I got the machine set up and now it comes up with "WIRE CUT W7 NOT READY". From what I have read on the forum, this means the software...
it is a A20B-0008-0430
But the puncher with the 50 pin ribbon cable does not plug into the puncher board, it plugs into the Motherboard at connector CAT. The puncher board connects to the RS232...
Hi agering
my machine does not have either of those part numbers, it does have the following
Tape reader unit A860-0056-T020
interface board that the 50 pin ribbon cable plugs into ...
Hi Everyone
I just picked up a used Advanced Digital Research BTR that I am looking to hook up to my Fanuc 6M (with a 50 pin cable). I have the connecting manual and maintanence manual but none of...
I tried G12, G12.1 G112 and I get a alarm (ps010).
in the g-code list in the users manual does not have a g12 or g12.1 in it but there is a section in the manual about g12.1
it is a colchester CNC650 and has a fanuc 10t controller
thanks
I tried g12 and g12.1 but they didnt work. never tried g112
have to try it mon
Hi
I work on a lathe at work that has live tooling but it has a option of Cartesian-to-polar interpolation, programming x and y on the lathe which converts it to x and c. but the option is not...
thanks for all the help
guess I was taking to big of steps
thanks alot :)
heres #1 at 1900
this is why I have a high #1
I thought the pixie ignored the following error and idle parameters when tuning
here is the tunning on running mode
the rough one is at 25000hz and the better one is 30000hz
I tryed 35000, 45000,55000 hz and they look rough
when I tryed 40000, 50000 and 60000 hz they look...
heres what the tuning graph looks like
I have tryed different values but it still gets following errors
the studdering is when it is ramping up speed, its like it overshoots on acceleration then...
the encoders are 5000 pulses per rev or 1250 cpr, I have the pixie multiplier set to 10 so I can get the higher speed since I dont have the purchased mach yet so I am limited to 25khz
I can get the...
wow, that was quick
I can put it in velocity or torque mode It think
in one option I cant turn the motor shafts, it tryes to stay in position
the other I think it torque, I can turn the shaft...
I wasnt able to get anymore information from cmc, so I just started playing around
found out that the top two connectors on the command connector are the +/- ref inputs, I think they might be +/-...
thanks for the quick response
I emailed cmc and the only thing they have is like a brochure, I looked through it, had specs but no descriptions on what each connector pin does
does anyone have a...
Hi
I picked up 4 CMC (cleveland machine controls) brushless amplifiers, power supply, and motors off ebay the other day.
my problem is trying to get them going
the amplifier model is BLA 2412
I...